Neabsco soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 36 to 52 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Neabsco soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Neabsco spot on the map
Rated from the USDA soil survey record for Neabsco loam, 0 to 7 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 8 in down: about 19% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2 A clay loam layer about 8 to 17 in down: about 27% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Loamy layerH3 A loam layer about 17 to 36 in down: about 25% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Loamy layerH4best layer A clay loam layer about 36 to 52 in down: about 27% clay, moderate plasticity when wet, brownish yellow when moist. Promising
- Loamy layerH5 A very gravelly sandy loam layer about 52 to 72 in down: about 18% clay, moderate plasticity when wet, brownish yellow when moist. Weak indication
What it looks like raw
The loamy layer (H4), 36 to 52 in down in the typical profile: brownish yellow (10YR 6/8). Raw colour is not fired colour.
About the soil
- Parent material: marine deposits.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Virginia, in these survey areas: Prince William County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia and Maryland. Moderate extent 6,500 acres in Prince William County.
USDA, geographic setting: Neabsco soils are on broad drainage divides of the older Northern Coastal Plain terraces. Elevations generally range from 150 to 300 feet. Slope gradients range from 0 to 15 percent but most areas are from 0 to 7 percent. The soil developed in stratified fluvio-marine sediments. On areas where the sediments are thin, these soils are underlain by residuum from Piedmont schist and gneiss. Mean annual precipitation range from 36 to 44 inches and mean annual temperature ranges from 52 degrees to 59 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Braddock: Strong lead
- Buckhall: Strong lead
- Calverton: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
See it on the map
Open a Neabsco spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Neabsco loam, 0 to 7 percent slopes, map unit 41B in Prince William County, Virginia.
- Official Series Description: Neabsco(revised 03/2022), established.
- Taxonomic class: Fine-loamy, siliceous, semiactive, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.