Monserate soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 10 to 28 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Monserate soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Monserate spot on the map
Rated from the USDA soil survey record for Monserate sandy loam, 0 to 5 percent slopes (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 10 in down: about 15% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A sandy clay loam layer about 10 to 28 in down: about 31% clay, moderate plasticity when wet, reddish brown when moist. Promising
- H3 An indurated layer about 28 to 45 in down: USDA gives no clay percentage or texture for it. Not enough data
- H4 A cemented layer about 45 to 57 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerH5 A loamy coarse sand layer about 57 to 70 in down: about 5% clay, low plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 10 to 28 in down in the typical profile: reddish brown (5YR 4/4), dark reddish brown (2.5YR 3/4) moist; extremely hard, very firm, very sticky, very plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: Interior valleys in the western part of southern California. The soils are of moderate extent.
USDA, geographic setting: The Monserate soils are on nearly level to moderately steep old dissected terraces and fans at elevations of 700 to 2,500 feet. The soils formed in alluvium derived principally from granitic rocks. The climate is dry subhumid mesothermal with long dry summers and mild moist winters. Mean annual precipitation is 12 to 18 inches. Average January temperature is 48 degrees to 52 degrees F., average July temperature is about 78 degrees F., and the mean annual temperature is 62 degrees to 65 degrees F. The freeze-free season is 230 to 280 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
See it on the map
Open a Monserate spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Monserate sandy loam, 0 to 5 percent slopes, map unit MmB in Western Riverside Area, California.
- Official Series Description: Monserate(revised 01/2003), established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Typic Durixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.