Placentia soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 18 to 39 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Placentia soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Placentia spot on the map
Rated from the USDA soil survey record for Placentia fine sandy loam, 0 to 5 percent slopes (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (27.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 18 in (46 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 18 in down: about 16% clay, low plasticity when wet, brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 18 to 39 in down: about 43% clay, high plasticity when wet, dark reddish brown when moist. Strong lead
- Loamy layerH3 A clay loam layer about 39 to 57 in down: about 28% clay, moderate plasticity when wet, strong brown when moist. Promising
- Sandy layerH4 A gravelly sandy loam layer about 57 to 60 in down: about 15% clay, low plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The clay-rich layer (H2), 18 to 39 in down in the typical profile: dark reddish brown (5YR 3/3), dark brown (7.5YR 3/4) moist; extremely hard, very firm, very sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from granite.
- USDA family particle-size class: fine.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: Mostly Salinas Valley and coastal parts of southern California. Placentia soils are extensive.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Porterville: Strong lead
- Vallecitos: Strong lead
See it on the map
Open a Placentia spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Placentia fine sandy loam, 0 to 5 percent slopes, map unit PlB in Western Riverside Area, California.
- Official Series Description: Placentia, established.
- Taxonomic class: Fine, smectitic, thermic Typic Natrixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.