Altamont soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 0 to 18 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Altamont soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Altamont spot on the map
Rated from the USDA soil survey record for Altamont clay, 5 to 15 percent slopes (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (32.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerH1best layer A clay layer about 0 to 18 in down: about 48% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layerH2 A silty clay layer about 18 to 23 in down: about 45% clay, high plasticity when wet, brown when moist. Promising
- BedrockH3 Bedrock about 23 to 27 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H1), 0 to 18 in down in the typical profile: brown (10YR 4/3), dark brown (10YR 3/3) moist; very hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sedimentary rock.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 23 in (58 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: In the Diablo Ranges in the California Coast Ranges in central and southern California and the Sutter Buttes. The soils are extensive. MLRA 15, 18, 20.
USDA, geographic setting: Altamont soils are on uplands, hills and mountains. Some Altamont soils are on slides on mountain slopes. Slope is 0 to 75 percent. Elevation is 100 to 4,480 feet. These soils formed in material weathered from fine-grained sandstone and shale. The climate is dry subhumid with hot dry summers and cool moist winters. Mean annual precipitation is 10 to 25 inches. Mean annual temperature is 57 degrees to 62 degrees F. The mean January temperature is about 45 degrees to 48 degrees F. and the mean July temperature about 65 degrees to 80 degrees F. The frost-free season is 180 to 340 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
- Vallecitos: Strong lead
See it on the map
Open a Altamont spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Altamont clay, 5 to 15 percent slopes, map unit AaD in Western Riverside Area, California.
- Official Series Description: Altamont(revised 11/2009), established.
- Taxonomic class: Fine, smectitic, thermic Aridic Haploxererts
- Rated with rule version 2026-09-28.1; the method is on the About page.