Marumsco soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 7 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Marumsco soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Marumsco spot on the map
Rated from the USDA soil survey record for Marumsco loam, 0 to 4 percent slopes (Prince William County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (37.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 7 in down: about 21% clay, moderate plasticity when wet, pale brown when moist. Possible
- Clay-rich layerH2best layer A clay layer about 7 to 29 in down: about 48% clay, high plasticity when wet, brownish yellow when moist. Strong lead
- Loamy layerH3 A sandy clay loam layer about 29 to 47 in down: about 34% clay, high plasticity when wet, gray when moist. Promising
- Loamy layerH4 A sandy clay loam layer about 47 to 75 in down: about 28% clay, high plasticity when wet, gray when moist. Promising
What it looks like raw
The clay-rich layer (H2), 7 to 29 in down in the typical profile: brownish yellow (10YR 6/6); firm, plastic and sticky. Raw colour is not fired colour.
About the soil
- Parent material: marine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Prince William County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Virginia; possibly Maryland. MLRA 149A. The series is of small extent.
USDA, geographic setting: Marumsco soils are on level to gently sloping low Coastal Plain terraces. These soils developed in stratified marine sediments of sand, silt and clay that contain a relatively high content of feldspar. These soils are commonly at elevations from about 5 to 30 feet above sea level. Mean annual precipitation ranges from 38 to 44 inches. Mean annual temperature ranges from 57 to 60 degree F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aden: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Braddock: Strong lead
- Buckhall: Strong lead
- Calverton: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
See it on the map
Open a Marumsco spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Marumsco loam, 0 to 4 percent slopes, map unit 37A in Prince William County, Virginia.
- Official Series Description: Marumsco(revised 03/2022), established.
- Taxonomic class: Fine, smectitic, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.