Kirksey soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 7 to 37 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kirksey soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kirksey spot on the map
Rated from the USDA soil survey record for Kirksey silt loam, 2 to 6 percent slopes (Davidson County, North Carolina) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 29% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (16.5).
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 12% clay, low plasticity when wet, pale yellow when moist. Weak indication
- Clay subsoilBtbest layer A silty clay loam layer about 7 to 37 in down: about 29% clay, moderate plasticity when wet, yellow when moist. Promising
- Sandy layerC A silt loam layer about 37 to 49 in down: about 15% clay, low plasticity when wet, mottled olive yellow when moist. Weak indication
- BedrockR Unweathered bedrock about 49 to 80 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 7 to 37 in down in the typical profile: yellow (2.5Y 7/6); firm. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from metavolcanics and/or residuum weathered from argillite.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
- Lithic bedrock typically about 49 in (124 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in North Carolina, in these survey areas: Davidson County, North Carolina.
By state: wild clay in North Carolina.
USDA, distribution and extent: The slate belt of South Carolina, North Carolina, and Virginia and possibly Alabama and Georgia. The series is inextensive.
USDA, geographic setting: Kirksey soils occur on saddles and lower slopes in uplands in the Piedmont. The soils formed in materials weathered from Carolina slate or other fine-grained rock. Slopes commonly are 2 to 6 percent but range from 0 to 10 percent. The mean annual temperature ranges from 59 to 64 degrees F., the mean annual precipitation ranges from 37 to 60 inches, and the frost-free season ranges from 190 to 230 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Armenia: Strong lead
- Badin: Strong lead
- Casville: Strong lead
- Cecil: Strong lead
- Clifford: Strong lead
- Davidson: Strong lead
- Davie: Strong lead
See it on the map
Open a Kirksey spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kirksey silt loam, 2 to 6 percent slopes, map unit KyB in Davidson County, North Carolina.
- Official Series Description: Kirksey(revised 03/2003), established.
- Taxonomic class: Fine-silty, siliceous, subactive, thermic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.