Juget soil
Wild-clay potential
Weak indication
Weak indication: no layer of Juget shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Juget soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Juget-Rock outcrop complex, 9 to 55 percent slopes (Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Moderate thickness (about 6 in (15 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1best layer A very gravelly sandy loam layer about 0 to 6 in down: about 12% clay, low plasticity when wet, dark gray when moist. Weak indication
- Sandy layerH2 A very gravelly loamy sand layer about 6 to 11 in down: about 5% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockH3 Weathered bedrock about 11 to 15 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H1), 0 to 6 in down in the typical profile: dark gray (10YR 4/1), black (10YR 2/1); soft, very friable. Raw colour is not fired colour.
About the soil
- Parent material: sandy residuum weathered from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 11 in (28 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Colorado, in these survey areas: Arapaho-Roosevelt National Forest Area, Colorado, Parts of Boulder, Clear Creek, Gilpin, Grand, Park and Larimer Counties; Boulder County Area, Colorado; Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
By state: wild clay in Colorado.
USDA, distribution and extent: Juget soils are extensive in the foothills along the eastern front of the Rocky Mountains and in other mountainous areas of central Colorado; MLRA 48A and 49.
USDA, geographic setting: Landform - mountain side slopes, hills and ridges
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Nunn: Strong lead
- Samsil: Strong lead
- Valmont: Strong lead
- Gaynor: Strong lead
- Heldt: Strong lead
- Kutch: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Juget-Rock outcrop complex, 9 to 55 percent slopes, map unit JrF in Golden Area, Colorado, Parts of Denver, Douglas, Jefferson, and Park Counties.
- Official Series Description: Juget(revised 05/2023), established.
- Taxonomic class: Sandy-skeletal, mixed, frigid Lithic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.