Hermon soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hermon shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hermon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Hermon sandy loam, 8 to 15 percent slopes, extremely bouldery (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOa An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerE A sandy loam layer about 2 to 3 in down: about 4% clay, low plasticity when wet, pinkish gray when moist. Weak indication
- Sandy layerBhs A sandy loam layer about 3 to 9 in down: about 4% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBs1 A very gravelly sandy loam layer about 9 to 16 in down: about 4% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBs2 An extremely gravelly loamy sand layer about 16 to 32 in down: about 1% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerCbest layer A very gravelly coarse sand layer about 32 to 65 in down: about 2% clay, low plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 32 to 65 in down in the typical profile: light olive brown (2.5Y 5/4); very gravelly coarse sand; loose. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly supraglacial meltout till derived from granite and gneiss.
- USDA family particle-size class: sandy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Maine, New Hampshire, in these survey areas: Coos County Area, New Hampshire; Somerset County Area and Parts of Franklin and Oxford Counties, Maine.
By state: wild clay in Maine,wild clay in New Hampshire.
USDA, distribution and extent: Maine, New Hampshire, and northern New York (MLRAs 142, 143, and 144B). The series is of large extent.
USDA, geographic setting: Hermon soils are on glaciated upland plains, hills, and ridges. Slope is dominantly 3 through 25 percent, but ranges from 0 through 60 percent. The soils formed in till derived mainly from granite and gneiss. The climate is humid and cool temperate. The mean annual precipitation ranges from 34 through 50 inches, and mean annual temperature ranges from 38 through 46 degrees F. The frost-free season ranges from 90 through 160 days. Elevation ranges from 5 through 2800 feet above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Becket: Weak indication
- Colton: Weak indication
- Hogback: Weak indication
- Marlow: Weak indication
- Peru: Weak indication
- Pillsbury: Weak indication
- Ricker: Weak indication
- Saddleback: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hermon sandy loam, 8 to 15 percent slopes, extremely bouldery, map unit 355C in Coos County Area, New Hampshire.
- Official Series Description: Hermon(revised 04/2016), established.
- Taxonomic class: Sandy-skeletal, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.