Grover soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 9 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Grover soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Grover fine sandy loam, 2 to 6 percent slopes (Cherokee, Gilmer, and Pickens Counties, Georgia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 29 in (74 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 9 in down: about 11% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A loam layer about 9 to 38 in down: about 27% clay, high plasticity when wet, yellowish red when moist. Possible
- Sandy layerH3 A sandy loam layer about 38 to 68 in down: about 15% clay, low plasticity when wet. Weak indication
What it looks like raw
The loamy layer (H2), 9 to 38 in down in the typical profile: yellowish red (5YR 5/6); friable; slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from mica schist and/or residuum weathered from gneiss.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Georgia, in these survey areas: Cherokee, Gilmer, and Pickens Counties, Georgia; Fulton County, Georgia.
By state: wild clay in Georgia.
USDA, distribution and extent: Piedmont areas of North Carolina, Georgia, South Carolina, and Virginia. The series is of moderate extent.
USDA, geographic setting: Grover soils are on gently sloping to steep ridges and side slopes on piedmont uplands. They formed in residuum that is affected in the upper part by soil creep on steep slopes, and is weathered from high-grade metamorphic rock high in mica such as biotite gneiss and schist. Slopes range from 2 to 45 percent. Elevation ranges from about 700 to 1200 feet. Near the type location, mean annual temperature is about 59 degrees F., and mean annual rainfall is about 64 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Hiwassee: Strong lead
- Madison: Strong lead
- Cecil: Strong lead
- Enon: Strong lead
- Gwinnett: Strong lead
- Hayesville: Strong lead
- Helena: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Grover fine sandy loam, 2 to 6 percent slopes, map unit GiB in Cherokee, Gilmer, and Pickens Counties, Georgia.
- Official Series Description: Grover(revised 10/2021), established.
- Taxonomic class: Fine-loamy, micaceous, thermic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.