Exeter soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 16 to 37 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Exeter soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Exeter sandy loam, 0 to 2 percent slopes (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 16 in down: about 15% clay, low plasticity when wet, brown when moist. Weak indication
- Loamy layerH2best layer A sandy clay loam layer about 16 to 37 in down: about 24% clay, moderate plasticity when wet, reddish brown when moist. Possible
- H3 An indurated layer about 37 to 50 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerH4 A stratified sandy loam to silt loam layer about 50 to 60 in down: about 10% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 16 to 37 in down in the typical profile: reddish brown (5YR 5/4), reddish brown (5YR 4/4) moist. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: Eastern side of San Joaquin Valley. The soils are extensive in MLRA-17.
USDA, geographic setting: Exeter soils are on hummocky, undulating to gently rolling alluvial fans and stream terraces at elevations of 20 to 700 feet. Slopes range from 0 to 9 percent. The soils formed in alluvium mainly form granitic sources. In most areas the hummocky relief has been smoothed by leveling. The climate is dry subhumid with hot, dry summers and cool, moist winters. The mean annual precipitation is 7 to 20 inches. The average January temperature is 46 degrees F.; the average July temperature is 82 degrees F.; and the mean annual temperature is 62 to 65 degrees F. The frost-free period is 250 to 300 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Exeter sandy loam, 0 to 2 percent slopes, map unit EnA in Western Riverside Area, California.
- Official Series Description: Exeter(revised 05/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Typic Durixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.