Colfax soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 12 to 27 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Colfax soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Colfax fine sandy loam, 2 to 6 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (11).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 12 in down: about 13% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2best layer A sandy clay loam layer about 12 to 27 in down: about 28% clay, moderate plasticity when wet, light yellowish brown when moist. Promising
- Loamy layerH3 A sandy clay loam layer about 27 to 54 in down: about 25% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Loamy layerH4 A sandy clay loam layer about 54 to 92 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The loamy layer (H2), 12 to 27 in down in the typical profile: light yellowish brown (2.5Y 6/4); firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from granite and gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Georgia, Virginia, in these survey areas: Douglas County, Georgia; Fauquier County, Virginia; Prince William County, Virginia; Spotsylvania County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Georgia,wild clay in Virginia.
USDA, distribution and extent: Piedmont Province of Alabama, Georgia, North Carolina, South Carolina, and Virginia. The series is of moderate extent.
USDA, geographic setting: Colfax soils are on divides at the base of hills and sideslopes of Piedmont uplands. Slopes are slightly convex or concave. Gradients are typically between 0 and 4 percent but the range is from 0 to 15 percent. These soils developed in material weathered from light colored granite or granite gneiss and similar materials. The mean annual precipitation ranges from about 40 to 46 inches and the mean annual temperature ranges from about 59 to 66 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Worsham: Strong lead
- Albano: Strong lead
- Caroline: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Jackland: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Colfax fine sandy loam, 2 to 6 percent slopes, map unit ClB in Stafford and King George Counties, Virginia.
- Official Series Description: Colfax(revised 07/1999), established.
- Taxonomic class: Fine-loamy, mixed, subactive, thermic Aquic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.