Cajalco soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 13 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cajalco soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cajalco spot on the map
Rated from the USDA soil survey record for Cajalco fine sandy loam, 2 to 8 percent slopes, eroded (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 13 in down: about 15% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH2best layer A loam layer about 13 to 30 in down: about 28% clay, moderate plasticity when wet, light yellowish brown when moist. Possible
- BedrockH3 Weathered bedrock about 30 to 62 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 13 to 30 in down in the typical profile: light yellowish brown (10YR 6/4), yellowish brown (10YR 5/4) moist; hard, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from gabbro.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: The Cajalco soils occur in the foothills and interior valleys of Southern California; they are of moderate extent.
USDA, geographic setting: The Cajalco soils occur on gently sloping to steep uplands in areas of deeply weathered, basic igneous rocks at elevations of less than 3,500 feet. The climate is one of long, dry summers and short, mild winters, with 9 to 16 inches average annual rainfall. The average January temperature is 50 degrees F, the average July temperature 72 degrees F, and the average annual temperature 62 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
See it on the map
Open a Cajalco spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cajalco fine sandy loam, 2 to 8 percent slopes, eroded, map unit CaC2 in Western Riverside Area, California.
- Official Series Description: Cajalco(revised 01/2003), tentative.
- Taxonomic class: Fine-loamy, mixed, active, thermic Mollic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.