Buren soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 12 to 30 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Buren soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Buren loam, deep, 2 to 8 percent slopes, eroded (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 12 in down: about 20% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH2best layer A loam layer about 12 to 30 in down: about 25% clay, moderate plasticity when wet, pale brown when moist. Possible
- Loamy layerH3 A loam layer about 30 to 40 in down: about 21% clay, moderate plasticity when wet, light olive brown when moist. Possible
- H4 A cemented layer about 40 to 52 in down: USDA gives no clay percentage or texture for it. Not enough data
What it looks like raw
The loamy layer (H2), 12 to 30 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; very hard, very firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from mixed sources.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: The soils are limited to the intermediate valleys of southern California. They are inextensive.
USDA, geographic setting: These soils are on gently to strongly sloping alluvial fans and terraces at elevations of about 700 to 3,000 feet. The soils formed in alluvium derived mostly from basic igneous rocks and partly from other crystalline rocks. They occur in a semiarid mesothermal climate with an average annual precipitation of 12 to 15 inches, an average January temperature of 51 degrees F, and average July temperature of 76 degrees F, and an average annual temperature of 61 to 65 degrees F. The frost-free season is about 230 to 300 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Buren loam, deep, 2 to 8 percent slopes, eroded, map unit BxC2 in Western Riverside Area, California.
- Official Series Description: Buren(revised 05/2006), established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Haplic Durixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.