Bremo soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bremo shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bremo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bremo loam, 6 to 15 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Note Moderate engineering plasticity index (8).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Lowers the potential High rock content (about 40% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A loam layer about 0 to 5 in down: about 15% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerH2best layer A very gravelly loam layer about 5 to 18 in down: about 15% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH3 A very gravelly silt loam layer about 18 to 30 in down: about 15% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- BedrockH4 Bedrock about 30 to 40 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H2), 5 to 18 in down in the typical profile: yellowish brown (10YR 5/8). Raw colour is not fired colour.
About the soil
- Parent material: mixed mafic residuum.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Virginia, in these survey areas: Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Virginia, Alabama, and possibly South Carolina, and Georgia. The series is of moderate extent.
USDA, geographic setting: Bremo soils are on narrow ridgetops and sideslopes in strongly dissected uplands of the Piedmont Plateau. Slope gradients are mostly between 7 and 15 percent and the extreme range is 2 to 45 percent. The soil formed in residuum weathered from dark colored rocks. The underlying rocks are mostly hornblende schist and gneiss, amphibolite, and hornblende gabbro. Mean annual precipitation is 40 to 45 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Bladen: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Craven: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Elbert: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bremo loam, 6 to 15 percent slopes, map unit BrD in Stafford and King George Counties, Virginia.
- Official Series Description: Bremo(revised 10/2021), established.
- Taxonomic class: Loamy-skeletal, mixed, semiactive, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.