Bourne soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 90 to 102 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bourne soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bourne fine sandy loam, 0 to 2 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 40% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 12 in (30 cm)).
- Lowers the potential Typically starts about 90 in (229 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 9 in down: about 13% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2 A sandy clay loam layer about 9 to 22 in down: about 28% clay, moderate plasticity when wet, light yellowish brown when moist. Possible
- Loamy layerH3 A fine sandy loam layer about 22 to 52 in down: about 18% clay, moderate plasticity when wet, yellowish red when moist. Possible
- Loamy layerH4 A sandy clay loam layer about 52 to 90 in down: about 25% clay, moderate plasticity when wet, dark red when moist. Weak indication
- Clay-rich layerH5best layer A clay layer about 90 to 102 in down: about 40% clay, high plasticity when wet. Promising
What it looks like raw
The clay-rich layer (H5), 90 to 102 in down in the typical profile. Raw colour is not fired colour.
About the soil
- Parent material: loamy marine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Virginia, in these survey areas: Prince William County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Virginia and southern Maryland, possibly North and South Carolina. The series is of moderate extent.
USDA, geographic setting: Bourne soils are on nearly level to sloping uplands. Slopes are dominantly 0 to 6 percent but range from 0 to 15 percent. The soil developed in stratified marine and fluvial deposits. The climate is temperate and humid. Mean annual precipitation is 35 to 47 inches. Mean annual temperature is above 59 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Susquehanna: Strong lead
- Worsham: Strong lead
- Aden: Strong lead
- Albano: Strong lead
- Bladen: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bourne fine sandy loam, 0 to 2 percent slopes, map unit BmA in Stafford and King George Counties, Virginia.
- Official Series Description: Bourne(revised 10/2021), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, thermic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.