Bethany soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 36 to 80 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bethany soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bethany spot on the map
Rated from the USDA soil survey record for Bethany-Pawhuska complex, 1 to 5 percent slopes (Osage County, Oklahoma) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 39% clay in the fine-earth portion.
- Note USDA labels this a "Btk" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (29): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 44 in (112 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 1% by volume).
- Note High shrink-swell (linear extensibility about 6%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilA A silt loam layer about 0 to 14 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerBA A silty clay loam layer about 14 to 18 in down: about 31% clay, high plasticity when wet, dark grayish brown when moist. Possible
- Clay subsoilBt A silty clay loam layer about 18 to 36 in down: about 39% clay, high plasticity when wet, brown when moist. Strong lead
- Clay subsoilBtkbest layer A silty clay loam layer about 36 to 80 in down: about 39% clay, high plasticity when wet, brown when moist. Strong lead
What it looks like raw
The clay subsoil (Btk), 36 to 80 in down in the typical profile: brown (10YR 5/3), brown (10YR 4/3) moist; very hard, very firm. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium derived from shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oklahoma, in these survey areas: Osage County, Oklahoma.
By state: wild clay in Oklahoma.
USDA, distribution and extent: Central Oklahoma and Kansas; LRR H, MLRA 80A; extensive, about 525,000 acres.
USDA, geographic setting: Parent material: loess or alluvium of Pleistocene age over shale of Permian age
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Agra: Strong lead
- Grainola: Strong lead
- Niotaze: Strong lead
- Parsons: Strong lead
- Prue: Strong lead
- Steedman: Strong lead
- Wynona: Strong lead
- Barnsdall: Promising
See it on the map
Open a Bethany spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bethany-Pawhuska complex, 1 to 5 percent slopes, map unit 12 in Osage County, Oklahoma.
- Official Series Description: Bethany(revised 01/2016), established.
- Taxonomic class: Fine, mixed, superactive, thermic Pachic Paleustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.