Bartlesville soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 9 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bartlesville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bartlesville spot on the map
Rated from the USDA soil survey record for Bartlesville-Bigheart complex, 1 to 5 percent slopes, very rocky (Osage County, Oklahoma) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 27% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (18).
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA A fine sandy loam layer about 0 to 4 in down: about 15% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerE A fine sandy loam layer about 4 to 9 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtbest layer A sandy clay loam layer about 9 to 36 in down: about 27% clay, moderate plasticity when wet, strong brown when moist. Promising
- BedrockCr Bedrock about 36 to 41 in down: no clay layer to dig. Weak indication
- BedrockR Bedrock about 41 to 51 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 9 to 36 in down in the typical profile: strong brown (7.5YR 4/6) broken face; firm, hard. Raw colour is not fired colour.
About the soil
- Parent material: loamy residuum weathered from sandstone.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 41 in (104 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oklahoma, in these survey areas: Osage County, Oklahoma.
By state: wild clay in Oklahoma.
USDA, distribution and extent: Northeast Oklahoma and southeast Kansas; LRR J, MLRA 84A. The series is of moderate extent.
USDA, geographic setting: Parent Material: material weathered from sandstone of Pennsylvanian age
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Agra: Strong lead
- Bethany: Strong lead
- Grainola: Strong lead
- Niotaze: Strong lead
- Parsons: Strong lead
- Prue: Strong lead
- Steedman: Strong lead
- Wynona: Strong lead
See it on the map
Open a Bartlesville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 53%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bartlesville-Bigheart complex, 1 to 5 percent slopes, very rocky, map unit BBgC in Osage County, Oklahoma.
- Official Series Description: Bartlesville(revised 01/2016), established.
- Taxonomic class: Fine-loamy, siliceous, active, thermic Oxyaquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.