Aura soil
Wild-clay potential
Weak indication
Weak indication: no layer of Aura shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Aura soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Aura gravelly fine sandy loam, 2 to 6 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note Thick enough to investigate (about 72 in (183 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 24% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A gravelly fine sandy loam layer about 0 to 12 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH2best layer A gravelly sandy clay loam layer about 12 to 84 in down: about 25% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
- Sandy layerH3 A gravelly sandy loam layer about 84 to 99 in down: about 18% clay, low plasticity when wet. Weak indication
What it looks like raw
The loamy layer (H2), 12 to 84 in down in the typical profile: yellowish red (5YR 5/8); very firm. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 11 map units in Maryland, Virginia, in these survey areas: Cecil County, Maryland; Prince William County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Maryland,wild clay in Virginia.
USDA, distribution and extent: Distribution: The Northern Coastal Plain and Northern Tidewater Area of New Jersey
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Susquehanna: Strong lead
- Worsham: Strong lead
- Aden: Strong lead
- Albano: Strong lead
- Bladen: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Aura gravelly fine sandy loam, 2 to 6 percent slopes, map unit AvB in Stafford and King George Counties, Virginia.
- Official Series Description: Aura(revised 11/2017), established.
- Taxonomic class: Coarse-loamy, siliceous, semiactive, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.