Arlington soil
Wild-clay potential
Weak indication
Weak indication: no layer of Arlington shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Arlington soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Arlington spot on the map
Rated from the USDA soil survey record for Arlington fine sandy loam, 8 to 15 percent slopes (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 11 in down: about 13% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2best layer A sandy loam layer about 11 to 24 in down: about 15% clay, low plasticity when wet, reddish brown when moist. Weak indication
- H3 A cemented layer about 24 to 36 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerH4 A coarse sandy loam layer about 36 to 47 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 11 to 24 in down in the typical profile: reddish brown (5YR 5/4), dark reddish brown (5YR 3/4) moist; hard, friable, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: Coastal and intermediate valleys of southern California. The soils are of moderate extent.
USDA, geographic setting: The Arlington soils are nearly level to strongly sloping and are on alluvial fans and terraces at elevations of about 400 to 2,000 feet. The climate is one of long dry summers and short mild winters with an average annual precipitation of 10 to 15 inches. The average January temperature is 51 degrees F., average July temperature is 76 degrees F., and average annual temperature is 63 degrees F. The freeze-free season is 240 to 320 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
See it on the map
Open a Arlington spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Arlington fine sandy loam, 8 to 15 percent slopes, map unit AnD in Western Riverside Area, California.
- Official Series Description: Arlington(revised 01/2003), established.
- Taxonomic class: Coarse-loamy, mixed, active, thermic Haplic Durixeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.