Arbuckle soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 12 to 26 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Arbuckle soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Arbuckle spot on the map
Rated from the USDA soil survey record for Arbuckle loam, 2 to 8 percent slopes (Western Riverside Area, California) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 12 in down: about 19% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layerH2best layer A loam layer about 12 to 26 in down: about 24% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Loamy layerH3 A gravelly loam layer about 26 to 45 in down: about 24% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH4 A stratified sandy loam to very gravelly sandy clay loam layer about 45 to 68 in down: about 20% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 12 to 26 in down in the typical profile: yellowish brown (10YR 5/4), dark yellowish brown (10YR 3/4) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from metasedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in California, in these survey areas: Western Riverside Area, California.
By state: wild clay in California.
USDA, distribution and extent: Along the west side of the Sacramento Valley and the intermountain valleys of the Coast Range and valleys of Southern California. The series is extensive. MLRA 17, 14, 15, 19, 20.
USDA, geographic setting: Arbuckle soils are on low terraces at elevations of 9 to 610 meters ( 30 to 2,000 feet) and have slopes of 0 to 75 percent. The parent material is alluvium derived from sedimentary and metamorphic rocks. Rock fragments are dominantly quartz and chert.. The climate is dry subhumid mesothermal with hot dry summers and cool moist winters. Mean annual precipitation is 25 to 89 centimeters (10 to 35 inches). Mean annual air temperature is 14 to 18 degrees C (57 to 64 degrees F.), average January temperature about 7 degrees C (45 degrees F.), and average July temperature about 28 degrees C (83 degrees F.) Frost-free season ranges from 152 to 280 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Altamont: Strong lead
- Auld: Strong lead
- Bosanko: Strong lead
- Las Posas: Strong lead
- Madera: Strong lead
- Murrieta: Strong lead
- Placentia: Strong lead
- Porterville: Strong lead
See it on the map
Open a Arbuckle spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Arbuckle loam, 2 to 8 percent slopes, map unit AkC in Western Riverside Area, California.
- Official Series Description: Arbuckle(revised 03/2018), established.
- Taxonomic class: Fine-loamy, mixed, superactive, thermic Typic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.