Allagash soil
Wild-clay potential
Weak indication
Weak indication: no layer of Allagash shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Allagash soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Allagash spot on the map
Rated from the USDA soil survey record for Allagash fine sandy loam, 3 to 8 percent slopes (Franklin County Area and Part of Somerset County, Maine) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 44 in (112 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Note Few rock fragments (about 12% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 5 in down: about 8% clay, low plasticity when wet, yellowish red when moist. Weak indication
- Sandy layerH2 A fine sandy loam layer about 5 to 21 in down: about 7% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerH3best layer A loamy fine sand layer about 21 to 65 in down: about 4% clay, low plasticity when wet, olive gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 21 to 65 in down in the typical profile: olive gray (5Y 5/2), and olive (5Y 5/3); loose. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy glaciofluvial deposits derived from slate.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Maine, in these survey areas: Franklin County Area and Part of Somerset County, Maine.
By state: wild clay in Maine.
USDA, distribution and extent: MLRAs 143, 144B, and 146 in Maine, Massachusetts, Vermont, and New York. The series is of moderate extent.
USDA, geographic setting: Allagash soils are on outwash plains and stream terraces. Slope ranges from 0 to 35 percent. Steep slopes are on terrace margin escarpments and sides of gullies in dissected outwash plains. The soils formed in materials derived mainly from granite, slate, schist, gneiss, phyllite and quartzite. The climate is humid and cool temperate. Mean annual precipitation ranges from 84 to 1219 mm, and mean annual temperature ranges from 3 to 7 degrees C. The frost-free season ranges from 80 to 160 days. Elevation ranges from 6 to 610 m above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Swanville: Possible
- Adams: Weak indication
- Brayton: Weak indication
- Bucksport: Weak indication
- Colonel: Weak indication
- Colton: Weak indication
- Croghan: Weak indication
- Fryeburg: Weak indication
See it on the map
Open a Allagash spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Allagash fine sandy loam, 3 to 8 percent slopes, map unit AgB in Franklin County Area and Part of Somerset County, Maine.
- Official Series Description: Allagash(revised 01/2017), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.