Sixmile soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 4 to 20 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sixmile soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sixmile spot on the map
Rated from the USDA soil survey record for Sixmile clay loam, 10 to 50 percent slopes, bouldery (Boulder County Area, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 32% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA A clay loam layer about 0 to 4 in down: about 33% clay, high plasticity when wet, reddish gray when moist. Possible
- Loamy layerBCk1best layer A clay loam layer about 4 to 20 in down: about 32% clay, high plasticity when wet, gray when moist. Promising
- Loamy layerBCk2 A loam layer about 20 to 30 in down: about 20% clay, moderate plasticity when wet, reddish gray when moist. Possible
- BedrockCr Bedrock about 30 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (BCk1), 4 to 20 in down in the typical profile: gray (5YR 6/1), dark gray (5YR 4/1) moist; hard, very friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum weathered from shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Colorado, in these survey areas: Boulder County Area, Colorado.
By state: wild clay in Colorado.
USDA, distribution and extent: Sixmile soils are of small extent in the foothills along the eastern front of the Rocky Mountains in central Colorado and in southeast Wyoming; MLRA 49 and 58B.
USDA, geographic setting: Landform - hills, pediments and homoclinal ridges of bedrock controlled landscapes
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Gaynor: Strong lead
- Heldt: Strong lead
- Kutch: Strong lead
- Longmont: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
See it on the map
Open a Sixmile spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sixmile clay loam, 10 to 50 percent slopes, bouldery, map unit SmF in Boulder County Area, Colorado.
- Official Series Description: Sixmile(revised 05/2023), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aridic Haplustepts
- Rated with rule version 2026-09-28.1; the method is on the About page.