Monadnock soil
Wild-clay potential
Weak indication
Weak indication: no layer of Monadnock shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Monadnock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Monadnock spot on the map
Rated from the USDA soil survey record for Monadnock fine sandy loam, 3 to 8 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 0% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 23 in (59 cm)).
- Note Typically starts about 42 in (106 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 7 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerBs1 A fine sandy loam layer about 7 to 9 in down: about 3% clay, low plasticity when wet, dark reddish brown when moist. Weak indication
- Sandy layerBs2 A gravelly fine sandy loam layer about 9 to 19 in down: about 3% clay, low plasticity when wet, yellowish red when moist. Weak indication
- Sandy layerBC A gravelly fine sandy loam layer about 19 to 22 in down: about 3% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layer2C1 A gravelly loamy sand layer about 22 to 42 in down: about 0% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Sandy layer2C2best layer A gravelly loamy sand layer about 42 to 65 in down: about 0% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (2C2), 42 to 65 in down in the typical profile: light brownish gray (2.5Y 6/2), and light gray (2.5Y 7/2); gravelly loamy sand; loose. Raw colour is not fired colour.
About the soil
- Parent material: loamy supraglacial meltout till derived from phyllite and/or granite and gneiss and/or mica schist over sandy and gravelly supraglacial meltout till derived from phyllite and/or granite and gneiss and/or mica schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 18 map units in Maine, New Hampshire, in these survey areas: Coos County Area, New Hampshire; Franklin County Area and Part of Somerset County, Maine.
By state: wild clay in Maine,wild clay in New Hampshire.
USDA, distribution and extent: Maine, Massachusetts, New Hampshire, New York, and Vermont. MLRAs 143 and 144B. These soils are extensive with about 750,000 acres of the series mapped.
USDA, geographic setting: Monadnock soils are nearly level to very steep soils on glaciated uplands. They are typically on convex parts of summits, shoulders, and backslopes. The soils formed in loamy over sandy Wisconsin age melt-out till derived mainly from schist, granite, gneiss, and quartzite. The till generally contains stones and/or boulders. Slope ranges from 0 to 80 percent. The mean annual precipitation ranges from 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost-free period ranges from 90 to 150 days. Elevation commonly ranges from 100m to 900m.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Swanville: Possible
- Adams: Weak indication
- Bucksport: Weak indication
- Colton: Weak indication
- Croghan: Weak indication
- Fryeburg: Weak indication
- Lovewell: Weak indication
- Lyman: Weak indication
See it on the map
Open a Monadnock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Monadnock fine sandy loam, 3 to 8 percent slopes, map unit 142B in Coos County Area, New Hampshire.
- Official Series Description: Monadnock(revised 06/2017), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, isotic over mixed, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.