Laporte soil
Wild-clay potential
Weak indication
Weak indication: no layer of Laporte shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Laporte soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Laporte spot on the map
Rated from the USDA soil survey record for Laporte very fine sandy loam, 5 to 20 percent slopes (Boulder County Area, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Moderate thickness (about 8 in (20 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
- Note USDA reports about 40% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1best layer A very fine sandy loam layer about 0 to 8 in down: about 16% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2 A loam layer about 8 to 13 in down: about 23% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- BedrockH3 Weathered bedrock about 13 to 17 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H1), 0 to 8 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard, very friable. Raw colour is not fired colour.
About the soil
- Parent material: calcareous loamy residuum weathered from limestone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 13 in (33 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Colorado, in these survey areas: Boulder County Area, Colorado.
By state: wild clay in Colorado.
USDA, distribution and extent: The Laporte series is extensive in Colorado, Montana, New Mexico, and Wyoming; MLRAs 35, 36, 48A, 49, 70, and 70A.
USDA, geographic setting: Landform - upland hills, cuestas and ridges
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Gaynor: Strong lead
- Heldt: Strong lead
- Kutch: Strong lead
- Longmont: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
See it on the map
Open a Laporte spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Laporte very fine sandy loam, 5 to 20 percent slopes, map unit LaE in Boulder County Area, Colorado.
- Official Series Description: Laporte(revised 05/2023), established.
- Taxonomic class: Loamy, carbonatic, mesic Lithic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.