Goldvale soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 26 to 49 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Goldvale soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Goldvale spot on the map
Rated from the USDA soil survey record for Goldvale, bouldery-Rock outcrop complex, 9 to 55 percent slopes (Boulder County Area, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (31): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 24 in (60 cm)).
- Note Typically starts about 26 in (65 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Organic top layerOe An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerE A stony coarse sandy loam layer about 2 to 18 in down: about 13% clay, moderate plasticity when wet, pink when moist. Weak indication
- Clay-rich layerE/B A stony sandy clay layer about 18 to 22 in down: about 43% clay, high plasticity when wet, mixed colors including pink when moist. Possible
- Loamy layerE/B A stony sandy clay loam layer about 22 to 26 in down: about 23% clay, moderate plasticity when wet, mixed colors including pink when moist. Weak indication
- Clay subsoilBtbest layer A stony sandy clay layer about 26 to 49 in down: about 43% clay, high plasticity when wet, reddish brown when moist. Promising
- Loamy layerC A stony coarse sandy loam layer about 49 to 60 in down: about 19% clay, moderate plasticity when wet, light reddish brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 26 to 49 in down in the typical profile: reddish brown (2.5YR 5/4), reddish brown (2.5YR 4/4) moist; extremely hard, friable, very sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from sandstone and shale.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Colorado, in these survey areas: Boulder County Area, Colorado.
By state: wild clay in Colorado.
USDA, distribution and extent: Goldvale soils are of moderate extent in the foothills along the eastern front of the Rocky Mountains in central Colorado and in alluvial valleys and mountain sides in southwestern Colorado; MLRAs 48A and 49.
USDA, geographic setting: Landform--side slopes of alluvial valleys, mountains, hogbacks and homoclinal ridges
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Gaynor: Strong lead
- Heldt: Strong lead
- Kutch: Strong lead
- Longmont: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
See it on the map
Open a Goldvale spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Goldvale, bouldery-Rock outcrop complex, 9 to 55 percent slopes, map unit GrF in Boulder County Area, Colorado.
- Official Series Description: Goldvale(revised 05/2023), established.
- Taxonomic class: Fine, smectitic, frigid Typic Haplustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.