Calkins soil
Wild-clay potential
Weak indication
Weak indication: no layer of Calkins shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Calkins soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Calkins spot on the map
Rated from the USDA soil survey record for Calkins sandy loam, 0 to 1 percent slopes (Boulder County Area, Colorado) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 46 in (116 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 14 in down: about 13% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH2best layer A sandy loam layer about 14 to 60 in down: about 12% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 14 to 60 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard, very friable. Raw colour is not fired colour.
About the soil
- Parent material: loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Colorado, in these survey areas: Boulder County Area, Colorado.
By state: wild clay in Colorado.
USDA, distribution and extent: Central Colorado in areas bordering the front range. The series is of moderate extent.
USDA, geographic setting: These soils are on flood plains or low terraces. Slope gradients range from 0 to about 5 percent. The soils formed in noncalcareous, moderately coarse textured parent materials derived from a variety of rocks. At the type location the average annual precipitation is 18 inches, but the soils are subject to restricted drainage and have fluctuating water tables. Mean annual temperature is 48 degrees F, mean summer temperature is 68 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Denver: Strong lead
- Englewood: Strong lead
- Gaynor: Strong lead
- Heldt: Strong lead
- Kutch: Strong lead
- Longmont: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
See it on the map
Open a Calkins spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Calkins sandy loam, 0 to 1 percent slopes, map unit CaA in Boulder County Area, Colorado.
- Official Series Description: Calkins, established.
- Taxonomic class: Coarse-loamy, mixed, mesic Cumulic Haplaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.