Bibb soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bibb shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bibb soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Bibb fine sandy loam, 0 to 4 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky.
- Note Thick enough to investigate (about 59 in (149 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 10 in down: about 10% clay, low plasticity when wet, variegated dark gray when moist. Weak indication
- Sandy layerH2 A fine sandy loam layer about 10 to 31 in down: about 10% clay, low plasticity when wet, gray when moist. Weak indication
- Sandy layerH3best layer A loamy fine sand layer about 31 to 90 in down: about 8% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 31 to 90 in down in the typical profile: gray (N 5/); slightly sticky. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: coarse-loamy.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in District of Columbia, Virginia, in these survey areas: District of Columbia; Stafford and King George Counties, Virginia.
By state: wild clay in District of Columbia,wild clay in Virginia.
USDA, distribution and extent: Coastal Plain of Alabama, Arkansas, Delaware, Florida, Georgia, Kentucky, Louisiana, Maryland, Mississippi, North Carolina, New Jersey, Oklahoma, South Carolina, Tennessee, Texas, and Virginia. The series is of large extent.
USDA, geographic setting: Bibb soils are on flood plains of streams in the Coastal Plain. Slopes are generally less than 2 percent. They formed in loamy and sandy alluvium. They flood frequently unless protected, and are subject to scouring and uneven deposition of overwash. The climate is humid subtropical. The average annual air temperature ranges from 59 to 72 degrees F., and the average annual precipitation ranges from 40 to 60 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Bladen: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Christiana: Strong lead
- Craven: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bibb fine sandy loam, 0 to 4 percent slopes, map unit Bb in Stafford and King George Counties, Virginia.
- Official Series Description: Bibb(revised 03/2014), established.
- Taxonomic class: Coarse-loamy, siliceous, active, acid, thermic Typic Fluvaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.