Sawpeak soil
Wild-clay potential
Weak indication
Weak indication: no layer of Sawpeak shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sawpeak soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sawpeak spot on the map
Rated from the USDA soil survey record for Sawpeak-Walkinshaw-McGravey complex, 60 to 90 percent north slopes (Olympic National Forest Area, Washington (Parts of Clallam, Grays Harbor, Jefferson, and Mason Counties)) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 22 in (55 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Lowers the potential High rock content (about 53% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 An extremely gravelly sandy loam layer about 0 to 5 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2 An extremely cobbly sandy loam layer about 5 to 14 in down: about 14% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH3best layer An extremely gravelly sandy loam layer about 14 to 36 in down: about 14% clay, low plasticity when wet, dark brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 36 to 40 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 14 to 36 in down in the typical profile: dark brown (7.5YR 3/4), strong brown (7.5YR 5/6) dry; slightly hard, friable, nonsticky and nonplastic; weakly smeary. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from basalt.
- USDA family particle-size class: medial-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 36 in (91 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Olympic National Forest Area, Washington (Parts of Clallam, Grays Harbor, Jefferson, and Mason Counties).
By state: wild clay in Washington.
USDA, distribution and extent: Mason and Jefferson Counties, Washington; MLRA 1. Series is of small extent.
USDA, geographic setting: Sawpeak soils are on mountain slopes, dissected mountain slopes, mountain headwalls, and glacial valleys. Slopes are 5 to 100 percent. The soils formed in colluvium from marine basalt and associated volcanic rocks. Elevations are 1,650 to 2,700 feet. Average annual precipitation is 70 to 150 inches. Average annual temperature is 41 to 45 degrees F. and frost-free season is 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aristine: Weak indication
- Ayock: Weak indication
- Brokenfinger: Weak indication
- Constance: Weak indication
- Dosewallips: Weak indication
- Fircreek: Weak indication
- Fricaba: Weak indication
- Govey: Weak indication
See it on the map
Open a Sawpeak spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 35%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sawpeak-Walkinshaw-McGravey complex, 60 to 90 percent north slopes, map unit 423D7 in Olympic National Forest Area, Washington (Parts of Clallam, Grays Harbor, Jefferson, and Mason Counties).
- Official Series Description: Sawpeak(revised 07/2000), established.
- Taxonomic class: Medial-skeletal, ferrihydritic, frigid Alic Hapludands
- Rated with rule version 2026-09-28.1; the method is on the About page.