McBiggam soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 46 to 80 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about McBiggam soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a McBiggam spot on the map
Rated from the USDA soil survey record for McBiggam silt loam, 2 to 8 percent slopes (Craters of the Moon National Monument and Preserve, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 46 in (117 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 5% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1 A silt loam layer about 0 to 3 in down: about 13% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilA2 A silt loam layer about 3 to 10 in down: about 13% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerBA A silt loam layer about 10 to 15 in down: about 26% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt A silty clay loam layer about 15 to 26 in down: about 27% clay, moderate plasticity when wet, light yellowish brown when moist. Promising
- Clay subsoil2Btb A silty clay layer about 26 to 36 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay subsoil2Btkb A silty clay layer about 36 to 46 in down: about 45% clay, high plasticity when wet, brown when moist. Strong lead
- Clay-rich layer2Bkbbest layer A silty clay loam layer about 46 to 80 in down: about 35% clay, high plasticity when wet, brown when moist. Strong lead
What it looks like raw
The clay-rich layer (2Bkb), 46 to 80 in down in the typical profile: brown (7.5YR 5/4), brown (7.5YR 4/4) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess and silty alluvium over residuum weathered from basalt.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Craters of the Moon National Monument and Preserve, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Small extent. South-central Idaho.
USDA, geographic setting: McBiggam soils are on basalt plains. Slopes range from 2 to 8 percent. Elevation ranges from 5,300 to 5,600 feet. The soil formed in loess and underlying material weathered from basalt. The average annual precipitation is 12 to 16 inches, most of which falls as snow and early spring rains. The average annual air temperature is about 40 to 43 degrees F. The frost-free season is 70 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- McCarey: Promising
- Nargon: Promising
- Deerhorn: Possible
- Cox: Weak indication
- Echocrater: Weak indication
- Infernocone: Weak indication
- Pagari: Weak indication
- Roundknoll: Weak indication
See it on the map
Open a McBiggam spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for McBiggam silt loam, 2 to 8 percent slopes, map unit 36 in Craters of the Moon National Monument and Preserve, Idaho.
- Official Series Description: McBiggam(revised 01/2011), established.
- Taxonomic class: Fine-silty, mixed, superactive, frigid Typic Palexerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.